Mody-pumps G 1006 T_SS316 Manuel d'utilisateur télécharger pdf (Page 7)

• LOOSEN SCREWS AND REMOVE CABLE CLAMP. LOOSE NUTS AND WITH THE HELP OF TWO

SCREWDRIVERS, PRY OUT CABLE GLAND. THE GLAND BASE WITH THE COMPLETE ASSEMBLY

WILL BE EXPOSED. IF STATOR IS TO BE RE-WOUND/OVERHAULED SNIP OFF CABLE LEADS

FROM WINDING LEADS. ALL RUBBER PARTS IN THE GLAND ASSEMBLY SHOULD BE

REPLACED WHENEVER THE GLAND IS REMOVED FROM CAVITY.

• LOOSE BOLTS - 4 NOS. AND PRY OFF TOP BRACKET FROM INNER CASING. IF TOOL KIT

IS AVAILABLE USE STATOR PULLER TO REMOVE TOP BRACKET FROM STATOR.

• THE STATOR IS SHRINK-FITTED IN THE INNER CASING. THE STATOR CAN NOW BE

CHECKED FOR ANY ELECTRICAL FAULTS. MEG-OHM TEST THE WINDINGS AND PERFORM A

LINE TO LINE RESISTANCE CHECK BETEWEEN THE WINDINGS. IF THE STATOR IS WET

BAKE IN AN OVEN FOR 4-5 HOURS AT 300F. HI-POT THE STATOR IF POSSIBLE AND

CHECK INSULATION WITH RESPECT TO GROUND.

• THE REVERSE OF THE ABOVE PROCEDURE CAN BE FOLLOWED FOR RE-ASSEMBLY OF THE

PUMP. PLEASE HOWEVER NOTE THE FOLLOWING:

A) ALWAYS REPLACE NEW O-RINGS AND DISCARD OLD ONES.

B) REPLACE NEW LOCK WASHER WHEN RE-ASSEMBLING.

OIL SPECIFICATIONS

A) SHELL TELLUS 29.

B) EXXON UNIVOLT 60/N61

C) CHEVRON SUPERLA FDA APPROVED WHITE OIL

APPROX. QUANTITY PER PUMP IS 6.5 LITER.

USE NON-CONDUCTING, NON-FOAMING FDA APPROVED OIL ONLY

ORDERING OF SPARE PARTS.

WHEN ORDERING SPARE PARTS PLEASE CLEARLY INDICATE THE PART NO. DEPENDING ON THE

MODEL OF THE PUMP AND THE OUTLET SIZE AND TYPE.

CONFIRM VOLTAGE AND FREQUENCY OF PUMP MODEL.

1 2 3 4 5 6 7 8 9 10 11 12 13

Pas de commentaire

Mody-pumps G 1006 T_SS316 Manuel d'utilisateur Page 7